Skip to main content

๐Ÿ‚ Autumn Sale Event โ€” Enjoy 15% OFF. Ends in --:--

River Thames boat name markings

Where a powered Thames boat name is displayed, and the minimum letter heights published by the Environment Agency.

7 min read

Last reviewed: 15 October 2026

Rules and materials guidance can change. Confirm details with the relevant UK authority before relying on stickers for a legal marking.

Powered boats on the non-tidal River Thames have a name-display rule that is separate from Small Ships Register numbers. Read the current Environment Agency page before you order. This summary follows the GOV.UK publication dated October 2016 and is not legal advice.

Name, plate and certificate are different things

The Environment Agency issues a registration certificate and a registration plate. The plate has to be displayed so the boat can be identified. The boat name is an additional marking: for a powered boat it must match the name on the registration certificate.

GOV.UK says the name goes on each side of the bow and on the stern. Narrowboats may show the name in the traditional way on each side of the cabin. Unpowered boats are not given the same name-size table on that page, so do not assume the powered-boat sizes apply to a canoe or skiff.

Published minimum letter heights

The October 2016 requirements page states these minimums for plain letters:

  • 5.1 cm for a boat no more than 6.09 m long
  • 7.6 cm for a boat between 6.09 m and 9.14 m
  • 10.2 cm for a boat between 9.14 m and 15.23 m
  • 15.2 cm for a boat longer than 15.23 m

Those figures are minimums for legibility, not a styling recommendation. A taller letter is still compliant if it stays plain and matches the registered name. The Thames section of our marking guide uses the same length bands in the designer presets.

SSR is not a Thames registration

An SSR number proves UK nationality for a Part III pleasure vessel. It does not replace an Environment Agency registration, plate or Thames boat name. If the boat uses both, order them as separate markings.

Design the name in the Thames designer or read the Thames product page.

Sources to check

Rules change. Read the current official page before you treat a size or placement as a requirement.