Boat lettering sizes
Separate aesthetic proportion, the space on the hull, and any minimum the relevant authority actually publishes.
6 min read
Letter height is doing two jobs that people often mix up: making the name look right on the boat, and meeting a minimum where an authority has published one. This page separates those jobs. It does not invent a single legal size for every UK boat.
Three different questions
- Fit. How much uninterrupted hull, transom or cabin side do you have, after rails, vents and rubbing strakes?
- Proportion. A 50 mm letter can look lost on a 12 metre cruiser and crowded on a tender. That is a design choice.
- A published minimum. Only some schemes publish one. River Thames powered boats have a length-based minimum on GOV.UK. Part III SSR regulation 95 does not state a letter height. Do not borrow a Thames or Part I figure for an SSR number.
Height changes width
The same name at a taller height is wider, and a script font is wider than a block font at the same height. The only reliable width is the one the boat name designer draws for your wording, font and height. Measuring a gap and then guessing “it will be about four times the height” is how names get ordered too wide.
Where to read the rules
Use River Thames boat name markings for the Environment Agency table, and SSR registration markings for the Small Ships Register. Canal & River Trust index and name placement is covered in the UK marking guide. Those pages are the ones to cite, not a generic “boat lettering must be 100 mm” claim.