How to measure boat lettering
A practical measuring sequence that uses the live designer instead of a guessed width.
6 min read
Measure the space, then let the designer tell you the width. A tape measure cannot see how wide a particular font will set.
What to measure
- Clean the area so you are measuring the hull, not dirt or an old letter edge.
- Mark the clear rectangle: the longest horizontal run that does not cross a fitting, stripe or tight curve you are unwilling to bridge.
- Measure that width in millimetres, and the vertical space if there is a window, rail or rubbing strake above and below.
- Repeat on the other side. Boats are often not symmetrical once fenders and outlets are included.
- If the name also goes on the transom, measure that panel separately. It is usually shorter.
Turn the measurement into an order
Open the boat name designer, type the name exactly as you want it, and raise the letter height until the preview width is inside the gap you measured, with space at both ends so the last letter is not on a curve. Script and outline styles need more width than plain block capitals at the same height.
For a Thames name, start from the minimum for your boat length in the Thames markings guide, then only go taller if the measured space allows it.
Mistakes we see on orders
- Measuring the whole boat length instead of the clear panel.
- Including the transfer-tape border as if it were the letter width. The designer width is the lettering, not the backing sheet.
- Changing the font after the size was approved. Set the font first, then the height.